Below are guides to help you estimate how much of our product you will need to complete your project
THEME ARMOR SYSTEM
THE RECOMMENDED THICKNESS OF THE 2605 CLEAR GLOSS IS 2-5 MILS DFT. THE THICKNESS OF THE 2610 (SATIN) AND 2615(FLAT) IS 1-3 MILS DFT PER LAYER SINCE IT IS IMPORTANT THAT THE GLOSS OF THE MATTE FINISHES WILL INCREASE DRAMATICALLY IF SPRAYED IN THICK LAYERS
SLIDE ARMOR COLOR SYSTEM
THE RECOMMENDED THICKNESS OF THE SLIDE ARMOR 2500 FOR THE INTERIOR OF SLIDE IS 8-10 MILS DFT . THE RECOMMENDED THICKNESS FOR EXTERIOR OF SLIDES OR FOR COATING FIBERGLASS PARTS IS 3-4 MILS DFT.
SLIDE ARMOR CLEAR SYSTEM
THE RECOMMENDED THICKNESS OF THE SLIDE ARMOR 2505 FOR THE INTERIOR OF SLIDE IS 3-5 MILS DFT . THE RECOMMENDED THICKNESS FOR FOR COATING FIBERGLASS PARTS IS 2-3 MILS DFT.
DECK ARMOR PRIMER SYSTEM
THE DECK ARMOR 2 REQUIRES A WATER BASED EPOXY FOR NEW CONCRETE.
DECK ARMOR 2 SYSTEM
THE DECK ARMOR SYSTEM REQUIRES TO BE APPLIED IN TWO COATS.THE FIRST COAT CAN BE APPLIED 10-15 MILS AND IS DESIGNED TO PROVIDE A UNIFORM BASE. THE FINAL TEXTURED COAT SHOULD BE APPLIED AT A MINIMUM OF 20 MILS DEPENDING ON THE DEGREE OF TEXTURE NEEDED.
SPLASH ARMOR SYSTEM RECOMMENDED THICKNESS
THE SPLASH ARMOR SYSTEM IS 30% HIGHER IN SOLIDS THAN MOST COMPETITIVE POOL COATINGS AND IS A HIGH BUILD SYSTEM THAT CAN BE APPLIED IN ONE COAT IF SPRAYED PROPERLY ON UNCOATED SURFACES BUT, IDEALLY IT IS BETTER TO FOLLOW INDUSTRY STANDARDS THAT SUGGEST 2 COATS IF THE SYSTEM IS ROLLER APPLIED ON BARE SUBSTRATES.
SPLASH ARMOR SYSTEM COVERAGE DETAILS
IN ORDER TO DETERMINE THE AMOUNT OF MATERIAL NEEDED, THIS CHART OUTLINES THE COVERAGE RATE AND THEORETICAL GALLONS NEEDED A DIFFERENT COATING THICKNESS LEVELS.